Applied to the surface of freshly laid concrete, SAFECURE SUPER physically ‘locks’ moisture into freshly cast concrete allowing full hydration of the cement thus ollowing the concrete to fully cure. This is achieved by covering the surface of the concrete with a very thin temporary mem- brane thot prevents moisture in the concrete from leaving the surface. Safecure Super has been tested, to show over 90% curing efficiency, when tested to BS 7542: 1992. Safecure Super is also a WRAS approved product.
Benefits of using include reduced surface shrinkage and cracking,; a more durable hard wearing surface and prevention of surface dusting.

SAFECURE SUPER is spray applied to the surface of newly placed concrete. The concrete should be free from surface water and the nozzle of the spray should be held approx. 450mm from the concrete surface and passed back and forth to ensure complete coverage. The pump pressure should be maintained at a level producing a fine spray. Rate of application recommended at 4- 6m2 per litre.
Touch Dry Time: ‹1 to 3 hours dependent upon temperature and wind Hard Dry Time: 16 to 20 hours dependent upon temperature and wind

Apply the selected grade by spray at a rate of approximately 4-6 m2 per litre, taking care to ensure complete coverage. Immediately after use the spraying equipment, especially the spray nozzle, should be thoroughly washed out with clean and if possible warm water. This will help ensure the nozzle does not become blocked with dried polymer latex and affect subsequent spraying.

Keep containers sealed. Store in dry conditions at room temperature and away from direct heat. Protect from frost. When stored correctly in on unopened container, storage stability is 12 months. If stored for more than 14 days please mix/agitate before use.

One year in sealed containers.

SAFECURE SUPER is manufactured by Adomast Manufacturing Ltd and shall be applied strictly in accordance with the manufacturer’s instructions. For specific advice regarding any aspect of this product, please consult our Technical Department

Avoid physical contact with material. If contact with skin should occur wash with soap and water. If splashes should affect eyes, bathe immediately with clean water and if discomfort persists seek medical advice.
See separate Safety Data Sheet for further information.