Adomast offer a wide range of Construction Repair Products.
• Polymer modified, low shrinkage,
high strength, water & chemical
resistant rapid drying repair mortars.
• Grey & White grades may be
blended to improve concrete colour
match.
▪ Tie hole repair mortar – Effectively
plugging the tie bar hole creating a
low shrinkage , high strength, water
tight mortar seal.
▪ Epoxy and Polyester Resin based
repair mortars – for very high
performance; high strength and high
chemical resistance repair &
anchoring compounds
Adopatch (Grey & White Colours)
• Rapid Set Repair Cementitious Mortar
• Pre-blended, ready-to-use, rapid drying mortar.
• Polymer modified, low shrinkage, high strength, water resistant repair mortar
• Good chemical resistance
• Compressive strength >30N/mm²
• Mix with small amount of water to produce an adhesive mortar suitable for patch repairs to
concrete.
• Two grades may be blended to improve colour match to concrete surface being repaired
High Flow Grout
• A non shrink, high strength cementitious grout based on high purity components to achieve high
in service performance
• The grout has high flow caricaturists to achieve penetration and levelling with zero shrinkage
and low bleed.
• Designed to provide a high strength fluid grout for pouring into and understation plated, machine
base plates and parapet rails for supporting bridge bearings
• Compressive strength >65N/mm² – can be used for grouting sections up to 100mm thick
Adoplug
• Polymer enhanced, high strength, shrinkage compensated cementitious premix.
• Tie hole repair mortar – creates water tight seal
– A 50mm plug can give up to 3m hydrostatic water resistance
– Hydrostatic resistance increases by 2m by every additional 50mm Adoplug
• Fast drying and curing mortar
• Compressive strength >30N/mm²
AdoGrout
• Powdered admixture for adding to grouts to mininimise shrinkage & normal settlement
• Positive expansion to ensure permenantly high bond to all contact surfaces
• Plasticiser aids mixing and flow with reduced water content – improved compressive strengths
• Improved frost resistance
Fill‘n’Rub
• Convenient method of filling blowholes & small surface defects in precast or cast insitu concrete,
providing an even, standardised colour and aesthetic finish, giving a durable and impermeable
repair
• Adopatch High Performance
– R3 Compressive Strength, fast curing repair mortar
• Adomast EasiFlow
– R4 Compressive strength, flowing structural repair concrete
– Available in rapid setting format & corrosion protection grades
• Adopatch High Build
– For vertical & overhead repair work
– Polymer modified, rapid setting & low shrinkage
• Steel Primer
– Pre blended powder based on acrylic polymers, anti-corrosion agents in a cementitious
base
– Designed as a bond enhancing coating for priming corroded steel reinforcement prior to
application of concrete repair material
– Ensures both maximum protection to the steel & full compatibility with the rest of the
reinforced concrete.
Resomast Mortar
A polyester resin & cementitious powder repair mortar
• A high performance repair resin based on crosslinked polyester technology. Designed to be
used for repairs to damaged concrete, masonry faces and many other applications where
high performance and durability is required.
• Very high strength (>90N/mm²), rapid drying, good chemical resistance & waterproof finish
• Suited for cold temperature applications <5°C
• Two-component; pre weighed liquid resin and hardener.
• Available in two pack sizes – 6kg and 12kg
