Epomast Crackseal is a two pack, solvent free, low
viscosity Epoxy resin designed for filling cracks and
voids in concrete, brickwork and masonry.
This allows the ready consolidation of structures, and
prevents water and salt ingress, thereby obviating freeze
thaw damage and re-bar corrosion.
For small scale repairs on site Epomast Crackseal may be
part mixed in the ratio of 4:1 by volume (Base to Curing
Agent component).
For large scale injection work, Epomast Crackseal may be
used with automatic proportioning pumps.

Apply the Epomast Crackseal by gravity feed or by
gunning or pumping into the cracks.
Injection flanges may be attached along the crack length
at nominal 150mm intervals using Epomast EPA or
Resomast Polyester Mortar.
For filling voids, simply fill by pouring.
Once the resin has cured it can be ground down to level,
or topped up if the level sinks.

The consumption of Epomast Crackseal is very much
dependent on the depth and extent of cracks within the
substrate.

Store in dry conditions, out of direct sunlight, at
temperatures between 10°C and 25°C.

Epomast Crackseal has a minimum shelf life of 12
months when stored in original, unopened containers in
accordance with manufacturer’s instructions.

Epomast Crack Seal by Adomast Manufacturing Ltd and shall be applied strictly in accordance with the manufacturers instructions.
For specific advice regarding any aspect of this product please consult our Technical Department

Avoid contact of the material with skin and eyes.
Wear gloves and goggles
Wash off splashes immediately with soap and water.
Any eye contamination must be rapidly irrigated with
copious amounts of clean water, and immediate medical
attention sought.
Please refer to Material Safety Data Sheet for additional
information