A two part bonding resin for general purpose repair and adhesion work which is very easy to mix and apply. Small amounts can be readily mixed to suit and it is a solvent free system, designed primarily for the decorative brick industry for use on lintels, chimneys, arches and brick slips but it is also fully suitable for general crack repair and filling as well as bonding masonry etc. together or to other surfaces. The resin is a fast cure system with gel times being less than 1 hour & ADOFIX RAPID is faster still with less than 30 minute gel times and primarily used for emergency repair. (See separate data sheet for ADOFIX RAPID) The resulting bond strength for both is generally higher than the material it is bonding together

SUBSTRATE PREPARATION:

The application surfaces must be sound, clean, dry and free from oil, grease or surface water wherever possible. Smooth surface should be abraded beforehand to maximise adhesion.
APPLICATION AND MIXING:
Remove the hardener ‘dish lid’ to reveal the resin component beneath.
Stir the resin well before use to avoid any resin settling
It is recommended that small quantities be used at any one time to enable ADOFIX to be applied before initial setting takes place. Transfer a golf ball sized of filler onto a suitable mixing board using the spreader present within the pack. Squeeze approximately 25mm of the hardener from the tube and mix. Mixing is best carried out with a folding action.
NOTE: Do NOT add excess hardener – this will NOT improve Gel / Cure time and ultimately may be detrimental to the curing effectiveness and lead to lower bonding strengths.
Apply ADOFIX with a trowel, spatula or scraper with a minimum thickness of 1mm. Ensure that adhesion takes place while ADOFIX is still mobile and tacky. Components should be supported during curing to avoid and prevent slippage.
Tools should be cleaned with Resoklens as quickly as possible to remove any uncured material.
GEL/CURING TIMES

TYPICAL PROPERTIES

Approximately 2m2 @1mm per 5 kilos of Adofix

ADOFIX is flammable. Store in a cool well ventilated area. Keep container tightly closed. Keep away from sources of ignition. Avoid any build-up of electrostatic charge in the immediate area. Ensure that lighting and electrical equipment nearby are not a source of ignition.

If stored in accordance to the above recommendations and sealed in unopened containers, then shelf life is approx. 24 months.

ADOFIX is manufactured by Adomast Manufacturing Ltd and shall be applied strictly in accordance with the manufacturers instructions. For specific advice regarding any aspect of this product, please consult our Technical Department

Adofix is classified as flammable and the hardener is classified as an irritant.
Ensure protective clothing is worn during use. If Adofix contacts the skin, wash off with soap and water. If irritation persists or a rash appears, seek medical advice.
For further information refer to the Safety Data Sheet.